I've had a few requests lately, asking how to determine which front end part needed to be replaced. I try to show how to check the inner tie rods, the outer tie rod ends, and the upper & lower ball joints. This is a combination of 3 different videos on 3 different vehicles. I hope this helps.


roadragecustomsDave is moving fast with his Road Rage Customs


HauntedTrailersThis is a video showing how to replace the fuel filter on a 2006 Ford Explorer. Other years, makes, models may or may not be similar. Thanks for watching! Check out www.youtube.com/roadragecustoms for more DIY automotive repair videos.


roadragecustomsThanks for watching! Please rate, comment & subscribe. This is video of a 2000 Ford F150 4x4 with very noisy ball joints. I show how to replace the front lower ball joints and the front upper control arms.


roadragecustomsThis is the step by step procedure to determine the cause of a failed charging system as well as the procedure to replace the alternator. Thanks for watching. Please rate & comment. Then check out my channel @ youtube.com/roadragecustoms & SUBSCRIBE.


This is a video of a 2006 GMC Sierra that had a check engine light & some evaporative emissions codes. I show how to diagnose the problem with a scan tool and the upgraded parts required to repair it. The codes in the PCM were P0449 & P0455. I repaired it with a procedure in GM TSB 02-06-04-0374...


Thanks for watching! Please rate, comment & subscribe. This is how to check the battery and charging system, as well as replace the alternator on a 2004 Honda Accord EX 4 cylinder. If you do it yourself you can save money. How-to DIY electrical diagnosis.


roadragecustomsThis is a video I made while replacing the rear differential pinion seal on a GMC truck. I did this one without removing the rear diff cover, but you can do it either way.


roadragecustomsThis video shows how to diagnosis & repair a common problem on some Honda vehicles. The A/C / heater blower fan wouldn't work due to a failed blower motor power transistor.


roadragecustomsThis video shows how to diagnose & repair a common problem on GM & Chevrolet trucks from about 1988-2003. The windshield wipers only worked occasionally. They usually didn't work when it was raining. It made driving really fun in bad weather. I've been driving around with the new part laying in...


roadragecustomsThese are pics & vids of me building a custom winch bumper for a 2009 Dodge Ram 1500 5.7L Hemi 4x4. I disassembled aftermarket aluminum fuel doors for full size GM trucks/SUV's for the rings around the lights in the center. I cut & drilled 1.25 inch thick steel from an old tractor bumper to make...


roadragecustomsThanks for watching! This is part 1 of 2 showing how to replace the water pump on a 2001 Chevrolet Silverado 2500HD with a 6.0L Vortec V8. You may want to turn the volume down at about 6:25.


roadragecustomsHere it is. Late as usual. The www.hornblasters.com Shocker 240 train horn video. This is the ultimate accessory for anyone who ever needs to get the attention of some moron on the street. I would like to thank Tony, my old service manager, and everyone who attended the 2011 Christmas parade in...


Thanks for watching! This is part 2 of 2 showing how to replace the water pump in a 2001 Chevy Silverado 2500HD with a Vortec 6.0L.


roadragecustomsThis is surveillance camera video of a GMC 2500HD repo attempt. The driver of the truck jumps back into his truck & rams the repo truck twice to get away. It happened Thursday May 3, 2012 @ SORS


roadragecustomsTHANKS FOR WATCHING! PLEASE SUBSCRIBE! DIY. This is how to replace your own serpentine belt if you have a Chevrolet Aveo 1.6L. Other year models may or may not be similar.


This is how to do your own brake job on a Jeep Wrangler. I show the right side front pad replacement, front rotor removal, and rear brake shoe adjustment. Thanks for watching! Please rate & comment on this video, then check out my channel & SUBSCRIBE!


This is a short video of a Ford Expedition with some neglected brakes. The vehicle was driven with brakes grinding metal-to metal until, not only the vents were contacting the pads, but the caliper pistons were hyper-extended so all the brake fluid came out. If your brakes are making noise, don't...


roadragecustomsThis is a short video of the Gatling gun kit I just built. It is 2 semi-auto Ruger 10/22 rifles on a tripod with a crank fire. I assembled according to the directions that came with the kit & only had to perform minor adjustments after the first test fire.


roadragecustomsThis is a video I made in August showing how to permanently repair a Honda Accord with a trunk that will not open. I had previously performed a temporary fix in December, but this is the best way to take care of the problem. Thanks for watching!


For DIY auto repair videos, visit www.youtube.com/roadragecustoms. Sorry, this is a camera phone video with no audio. Thanks to Jeff @ Chandler Automotive Services for permission to use the footage. (www.chandlerautomotiveservices.com) There is a bad intersection near my old job that collects...


roadragecustomsThis is a short video showing how to repair a 1995 Chevrolet S10 with flickering headlights. I show how to replace the headlight switch & the "pigtail" connector. Thanks for watching! Please rate & comment, then check out my channel for more do it yourself auto repair videos. If you haven't...


roadragecustomsI built an AR15 & recently decided to send a few green-tipped rounds of 5.56 penetrator ammo through some propane tanks sitting in front of a small fire. This is what happened.


roadragecustomsThis is a video of a 1997 Ford Explorer with burned out dash lights & an inaccurate gear select indicator. I show how to remove the instrument cluster, change the bulbs, & replace the shift indicator. While editing the video, I noticed that I couldn't stop saying "now". Sorry. You'll see what I...


roadragecustoms
Страница: 1 из 5
